|
 |
| Step 1: |
|
 |
|
The back part of the diamond has to be completely free from any trace of grease and dust. The most appropriate way to apply the diamond is as follows: use the STICK , a tiny stick that permits you to take the diamond without touching it with your fingers. Clean the tooth's surface with water and a cotton roll and dry it.
|
|
| |
| Step 2: |
|
| Apply a drop of mordant on the point where you exactly want to fix the diamond, leave the mordant not more than 20 seconds on the fixing point, dip a cotton roll in the water, rinse well the part of the tooth and then dry it. |
|
|
| |
| Step 3: |
|
| Apply a drop of the glue on the surface previously treated with the small BRUSH , then place the light of the STARLIGHT photopolymerizing lamp on the front part of the tooth for 20 seconds. |
|
|
| |
| Step 4: |
|
 |
|
Put a drop of composite on the treated surface; use a very small quantity of composite for the application of the diamond. |
|
| |
| Step 5: |
|
Apply the diamond with the STICK, then position the light of the STARLIGHT photopolymerizing lamp first on the rear part of the tooth for 20 seconds, subsequently place it on the front part for 20 more seconds. This last step is necessary to harden the applied material. |
|
|
|
Now your diamond is fixed, if necessary, you can gloss the diamond with a small piece of cotton. |
| |
| Advices: |
|
|
To assure an ideal hold, please pay mainly attention to point 1 and 2, and follow all the subsequent steps.
The application on a natural tooth carefully observing the procedure described above will last for approximately 1 year.
rush your teeth as usual with toothbrush and toothpaste, and be careful when biting into hard food. |
| |
| |
